IM SOLO 3 IT (with Multi MASSter, HPA & DCO software included)

.: MD5 and CRC32 Hashing: Simultaneous MD5 and CRC32 hashing generation can be performed during the data copy opration. (Note: Hashing is supported using the sector-by-sector copy mode only)
.: Touch Screen User Interface: The unit’s advanced Touch Screen User Interface and programmed keyboard provides for ease of use.
.: High Speed Operation: Data copied at transfer rates that exceed 3GB/min.
.: Built in Write Protection: Source's data is protected with built-in write protection.
.: Built in FireWire 1384B and USB 2.0 Interface: Copy data from a Source's unopened Notebook or PC. Also, safely preview the Source's drive while connected to the IM Solo-3's write protected port.
.: Copy to Two Target Drives Simultaneously: Copy data to two hard drives simultaneously at high speeds, without speed reduction.
.: Multiple Copy Methods: Copy data using a sector-by-sector copy mode or using the ICS' Intelligent Copy mode, which copies only allocated files.
.: WipeOut: Sanitize drives and erase data at speeds greater than 3GB/min.
.: Multiple Media Support: Supports data transfer between P-ATA, S-ATA and SCSI hard disk drives (Note: SCSI drives are supported with optional hardware). Also supports imaging data from flash media devices and Notebook drives.
.: Upgradable: Software and Firmware upgrades performed using the supplied Compact Flash Card.

Note: It's highly recommended to use the Hard Drive Shield and Coolers with the Solo 3 IT. This accessory will protect the hard drive from EMI noise while you clone hard drives and will reduce heat build-up of the hard drives.

Changes in software version 1.0.8.0p (January 2009):
- Provided improved transfer rate for drives supporting 48-bit addressing.
Depending on drive models, the new version can improve transfer rates by 50% with hashing disabled and 45% with hashing enabled.
- Adds support for the ICS DiskCypher Hardware1 (optional hardware purchase). DiskCypher1 allows for the encryption of data on evidence drives.
- Provides improved Linux-IQCopy support for source drives containing Linux extending partitions located between primary partitions.
- Provides improved SCSI drive detection support.
- Provides improved drive detection support when using the SCSI-to-SATA adapter.

Changes in firmware version 5.0.4.10 (January 2009):
- Provides improved bad sector handling support.
- Provides improved drive handling support required for some drive models.